Ingersoll Rand W5132 IQV20 Series Impactool

Ingersoll Rand W5132 IQV20 Series Impactool, 3/8″ Review

Ingersoll Rand W5132 IQV20 Series Impactool

Ingersoll Rand W5132 IQV20 Series Impactool



Ingersoll Rand W5132 is a 2016 release 20 Volt battery powered 3/8 inch impactool as part of the IQV20 Series, with 50% more torque (up to 365 ft-lbs maximum torque and 550 ft-lbs nut-busting torque) and power than other similar impactools, the most impressive power-to-weight ratio that can be compared to the pneumatic impact wrenches. IQV20 series impactools come with a smart power control system with 4 settings of mid power, full power, wrench tight and hand tight so you get the optimal amount of torque from it for different type of tasks (varying degrees of torque between max torque and hand tight) and each mode works with the maximum reverse torque. You can tighten and loosen different fasteners with the right amount of precise power and control settings so you get things done quickly and efficiently. It has a solid brushless motor housed in a chemical and impact resistant composite casing and with a steel reinforced frame protection so it will last you much longer. For improved visibility the 60 lumen Chip-on-Board (COB) LED light ring is designed shadowless and 360 degree with a task light and 4 dimmable modes for low, medium and high light environments.

Ingersoll Rand W5132 IQV20 Impactool

Ingersoll Rand W5132 weighs 4.5 pounds and measures 6.5 x 3.1 x 8.6 inches (it has a short design- 6.5 inches tip-to-tail) so you can get into smaller areas and corners easily. You have the options of getting as tool only, as a 1/2 inch tool, in a kit of tool/battery and charger or with two batteries. Ingersoll Rand is a well known brand of a 13 billion dollar company worldwide for high quality, reliable and functional tools and this powerful IQV20 series tool is created for use by operators and technicians in different areas for different maintenance and repair applications such as the machine rebuilds, manufacturing equipment repair, flange bolts and equipment disassembly, so you can achieve good results by using less power tools. At the highest setting of 340 foot pounds you can easily tighten the bolts on flanges, axles and transmissions and you can deal with stuff that don’t require that much power in mid power at 240 foot pounds and lower settings or wrench tight at 10 to 24 foot pounds and hand tight at 2 to 9 foot pounds and automatic shut-off at impact point. You don’t have the compressor or the hose but great power and torque that can be compared to pneumatic units in a small form factor.

Click here for a closer look on Amazon